Briggs JR 206 Kid Kart
KID KART MOTOR MOUNT
The introduction of the Briggs & Stratton Kid Kart engine has made it possible to
purchase one engine that can grow in Horsepower as the racer grows from a Kid
Kart into adult classes.
Your Kid Kart chassis will soon be too small for your son or daughter but not the
engine. A few simple modifications can increase the horsepower as the drives driver’
s skills improve with age.
The 4100-rpm rev-limiting coil that comes on the Jr. 206 can be replaced and the
throttle stop removed to increase engine performance.
Growing from Kid Kart to unrestricted can be done with one engine.
Most Kid Kart chassis were made for a 2 cycle Comer engine and require an adaptor
plate to mount the Junior 206 Briggs engine.
Www.Fastermotors.net has engineered the first Junior 206 adaptor plate designed to
fit any of today's kid’s kart chassis featuring a welded, raised Comer plate.
'Fastermotors has made converting your kids kart to the Junior 206 engine as simple
this plate to the chassis, setting on the engine, and off you go' stated
Dave Klaus, Briggs & Stratton.
ANIMAL / WF ONBOARD ELECTRIC START KIT
Complete Starter, Starter Solenoid, Start switch, Starter
Brace, Ring gear and bolts and Starter gear cover.
Everything you need
Model 15 block and cylinder support.
Adds strength to bearing pocket,
covers oil passage and ties cylinder to
the block. No welding. Uses existing
bolt holes and high strength epoxy.
Epoxy not included.
Yellow so you can see it better. $34.95
Emulsion tube tool
Remove emulsion tube without
removing float bowl.
305 & 324 BIG
Complete with all fasteners
NEW DESIGN ANIMAL ROLLER ROCKERS
REPLACES ORIGINAL STAMPED STEEL STUD
PLATE WITH A ONE PIECE PLATE AND ROCKER
PEDESTAL. HAS 1/2" PIN FOR ROCKERS TO PIVOT
ON. HARDENED ROLLER WITH EXTRA MATERIAL
TO RETAIN THE LONG PIN. USES 1/8" ALLEN
WRENCH FOR ADJUSTMENT BUT USES LIGHT
WEIGHT 5/16' LOCK NUT.
ACCEPTS VALVE SPRINGS THAT DON'T COIL BIND
WITH HIGH LIFT CAMS.
USES STOCK VALVE COVER. NO NEED FOR VALVE
Briggs 342 cc (21 cubic inches) Roller Rockers.
Available in 1.2, 1.3 and 1.4 to 1 ratio.
Unlike other rockers they take standard length push rods and they
fit under the stock valve cover. They are also wider at the roller tip
to retain the pins. PRICE $199.95
Setting the slide opening at the legal
maximum is one of the most important
things you can do with your LO 206 to
assure you are making maximum
power. These GO No GO Carb Slide
Gauges allow you to do set the
opening as close to the maximum that
you feel comfortable with.
Price $19.95 ea
THESE ARE NOT OFFICIAL
CERTIFIED TECH TOOLS
MIKUNI INTAKE MANIFOLDS
FOR 24 & 28 MM CARBS. CARB SLIDES DIRECTLY
INTO THE MANIFOLD. ASSURES CONSISTENT AND
SOLID ALIGNMENT OF CARB TO MANIFOLD.
NO RUBBER HOSE THAT CAN DEFORM OVER TIME